≥1:
AU $3.14543
Buy(0)
Inquiry(0)
Dear customers, due to the implementation of the GDPR policy in Europe, UTSOURCE has also made adjustment accordingly to meet the policy requirements. Please read the new privacy policy carefully and this window will no longer pop up after you accept it.
Delivery Address
+ Add Address
The new shipping address
* Please fill in the cell phone number correctly to make sure that you can receive the tracking info in time.
Country CodeSearch results filter:
Home > Elec-component > IC Chips > Interface - Drivers, Receivers, Transceivers
DIP-16
Texas Instruments
01+
Quadruple Differential Line Receiver 16-PDIP 0 to 70
SN75ALS193N is a 16-pin DIP (dual in-line package) from Texas Instruments. It is a 4-bit synchronous binary up/down counter. Description: The SN75ALS193N is a 4-bit synchronous binary up/down counter
Stock:10000
Minimum:2
Favorite
SN75ALS174DWR is a SOP-20 package from Texas Instruments. It is a Quadruple Positive-Edge-Triggered D-Type Flip-Flop. Description: The SN75ALS174DWR is a quadruple positive-edge-triggered D-type flip
Stock:10000
Minimum:2
Favorite
Stock:10000
Minimum:1
Favorite
SSOP-28
Intersil/harris
04+
LINE TRANSCEIVER|CMOS|4 DRIVER|5 RCVR|SSOP|28PIN|PLASTIC
Stock:10000
Minimum:2
Favorite
Description: The SN75158P is a quad differential line receiver designed for digital data transmission over balanced lines. Features: - Low power consumption - High noise immunity - High common-mode r
Stock:10000
Minimum:2
Favorite
DIP8
Microchip Technology
High Speed CAN Transceiver, -40C to +85C, 8-PDIP, TUBE
MCP2551-I/P is a high-speed CAN transceiver manufactured by Microchip. It is a 8-pin DIP package and is used to interface a CAN controller to the physical bus. Description: The MCP2551-I/P is a high
Stock:10000
Minimum:2
Favorite
Stock:10000
Minimum:1
Favorite
Stock:10000
Minimum:2
Favorite
The GS6080-INTE3 is a low-power, low-noise, low-dropout linear regulator (LDO) from Semtech Corporation. It is a 16-pin QFN package with a maximum output current of 1.5A. The GS6080-INTE3 features
Stock:5000
Minimum:1
Favorite
Description: The MC1489P is a dual line receiver designed for use in balanced data transmission systems. Features: - Low power consumption - High common-mode rejection ratio - High input impedance -
Stock:10000
Minimum:5
Favorite
Description: Dual, High Side, Low Side, 2A, 30V, Low Voltage, MOSFET Driver Features: - High-side and low-side MOSFET drivers - 2A peak source and sink current - 30V maximum supply voltage - Low volta
Stock:10000
Minimum:2
Favorite
The UA9638CP is an 8-pin DIP (Dual In-line Package) voltage regulator from Texas Instruments. It is a low-dropout (LDO) linear regulator with a fixed output voltage of 5V. The UA9638CP is designed to
Stock:10000
Minimum:2
Favorite
Description: The TJA1051T/3/CM is a high-speed CAN transceiver from NXP USA. It is designed to interface a controller area network (CAN) protocol controller with the physical two-wire CAN bus. Featur
Stock:10000
Minimum:2
Favorite
Description: RS-232 Transceiver with ±15kV ESD Protection Features: Low Supply Current: 4.5mA (Typ) ±15kV ESD Protection on All Pins Low Shutdown Current: 0.1μA (Typ) Low Output Skew: 0.5ns (Typ)
Stock:5000
Minimum:1
Favorite
Description: The AR8035-AL1B-R is an Ethernet physical layer transceiver (PHY) from Qualcomm. It is a single-port, 10/100/1000 Mbps Ethernet PHY that supports both 10BASE-T and 100BASE-TX, as well as
Stock:5000
Minimum:1
Favorite
Description: Low-Voltage, Low-Power, ±15kV ESD-Protected, 2.7V to 5.5V, RS-485/RS-422 Transceivers Features: ±15kV ESD Protection on RS-485/RS-422 I/O Pins Low-Voltage Operation: 2.7V to 5.5V
Stock:10000
Minimum:2
Favorite
TI) Description: The AM26C31CNSR is a 16-pin SOIC (Small Outline Integrated Circuit) from Texas Instruments. It is a low-power, high-speed, quad differential line driver designed for digital data tra
Stock:10000
Minimum:2
Favorite
SOP-8
National Semiconductor
RES,Wirewound,0.22Ohms,5% Tol,-90,90ppm-TC,2515-Case
The DS89C21TM is a high-speed, low-power 8-bit microcontroller with 8K bytes of on-chip ROM and 128 bytes of on-chip RAM. Features: 8K bytes of on-chip ROM 128 bytes of on-chip RAM 8-bit CPU
Stock:10000
Minimum:2
Favorite
DIP-20
Maxim Integrated
0428/0434/
Circular Connector; MIL SPEC:MIL-DTL-38999 Series III; Body Material:Metal; Series:D38999/20; No. of Contacts:26; Connector Shell Size:17; Connecting Termination:Crimp; Circular Shell Style:Wall Mount Receptacle; Body Style:Straight RoHS Compliant: No
Stock:10000
Minimum:1
Favorite
The BCM5221A4KPTG is a single-chip 10/100 Ethernet physical layer device from Broadcom. It is a low-power, low-cost, full-featured 10/100 Ethernet physical layer transceiver. Features: * 10/100 Mb
Stock:2000
Minimum:1
Favorite
Stop production experts, we can provide a large number of electronic components that have been stopped production and are difficult to find, to facilitate the maintenance company