LM3915

422LP25R : Two Channel. This to RS-422 converter converts unbalanced RS-232 signals to balanced RS422 signals. The power used for this converter is derived from the transmit data line (pin 2) and the handshake control lines (pins and 20). The converter can derive power from these lines when they are in the positive or negative voltage state. This permits the converter to be used.

74LVTH32245G : Low Voltage 32-bit Transceiver With 3-state Outputs. The LVT32245 and LVTH32245 contain thirty-two noninverting bidirectional buffers with 3-STATE outputs and are intended for bus oriented applications. The devices are byte controlled. Each byte has separate control inputs which can be shorted together for full 32-bit operation. The T/R inputs determine the direction of data flow through the device. The OE inputs.

CD54AC2453A : Octal-bus Transceiver Three-state, Non-inverting. The CD54AC245/3A and CD54ACT245/3A are octal-bus transceivers that utilize the Harris Advanced CMOS Logic technology. They are non-inverting three-state bidirectional tranceiver-buffers intended for two-way transmission from "A" bus to "B" bus or "B" bus to "A" bus. The logic level present on the direction input (DIR) determines the data direction.

INT201 : Floating Inputs Floating High-side Drive. Floating Control Inputs Connects directly or INT202 HSD outputs No external level translators or transformers required Gate Drive Output for an External MOSFET Provides sink/150 mA source current Can drive MOSFET gate 15 V Floating source for driving high-side N-channel MOSFET External MOSFET allows flexibility in design for various motor sizes Built-in.

ISP1181A : ISP1181A; Full-speed Universal Serial Bus Interface Device;; Package: SOT362-1 (TSSOP48), SOT619-2 (HVQFN48).

M51971 : Motor Speed Control (f-g Type). The is a semiconductor integrated circuit designed to control the motor rotating speed. The built-in FG amplifier with high gain enables to use a wide range of rotating speed detector (FG detector). Use of less external parts enables DC motors to be controlled with high precision. Non-inverted input Inverted input Amplifier output q Wide range of supply.

ML6509 : Active Scsi Terminator. The ML6509 BiCMOS SCSI terminator provides active termination in a SCSI system with single ended drivers and receivers, in full compliance with the SCSI-1, SCSI-2 and SCSI-3 recommendations. It provides a 2.85V reference through an internal 1V dropout linear regulator. Active SCSI termination helps the system designer to effectively control analog transmission.

N74F245DB : Octal Transceiver 3-state. Octal bidirectional bus interface 3-State buffer outputs sink 64mA 15mA source current Outputs are placed in high impedance state during power-off The is an octal transceiver featuring non-inverting 3-State bus compatible outputs in both transmit and receive directions. The B port outputs are capable of sinking 64mA and sourcing 15mA, producing very.

TUSB2043VF : USB Hub Controllers. ti TUSB2043, 4-Port Usb Hub W/optional Serial EePROM Interface (Input Clock: 48 MHZ Oscillator/clock Source).

V3xxEPC : PCI Controllers. Enhanced Pci Bridge Controller. w Direct interface to these processors: AMD® AM29030/40TM IBM® PowerPC 401TM Gx Intel® i960® Cx/Hx/Jx/Sx w Fully compliant with PCI Local Bus , Revision 2.1 w Configurable for system master, PCI bus master, or PCI target operation w Type 0 and Type 1 PCI configuration cycles 1 kB burst access on the PCI or the local bus w 640 bytes of programmable FIFO.

74LVT16500A : General The 74LVT16500A is a high-performance BiCMOS product designed for VCC operation at 3.3 V. This device is an 18-bit universal transceiver featuring non-inverting 3-state bus compatible outputs in both send and receive directions. Data flow in each direction is controlled by output enable (OEAB and OEBA), latch enable (LEAB and LEBA), and clock.

DS91D176 : The DS91C176 and DS91D176 are high-speed M-LVDS differential transceivers designed for multipoint applications with multiple drivers or receivers. Multipoint LVDS (M-LVDS) is a new bus interface standard (TIA/EIA-899) based on LVDS but including several enhancements to improve multipoint performance. M-LVDS devices have superior drive capability and can support.

ISL3293E : ±16.5kV ESD Protected, +125°C, 3.0V to 5.5V, SOT-23/TDFN Packaged, Low Power, RS-485/RS-422 Transmitters The Intersil ISL3293E, ISL3294E, ISL3295E, ISL3296E, ISL3297E, ISL3298E are ±16.5kV HBM ESD Protected (7kV IEC61000 contact), 3.0V to 5.5V powered, single transmitters for balanced communication using the RS-485 and RS-422 standards. These drivers.

DS3508 : I²C, 8-Channel Gamma Buffer With EEPROM The DS3508 is a programmable 8-channel gamma voltage generator with one byte of on-chip EEPROM and one byte of SRAM memory per channel. Each channel is composed of an independent 8-bit DAC with an associated EEPROM/SRAM pair. At power-up, nonvolatile (NV) EEPROM gamma data is loaded into its corresponding SRAM.

TUSB8040 : SuperSpeed USB (USB 3.0) 4–port Hub Controller The TUSB8040 is USB 3.0 compliant hub available in an 80-pin QFP package. The device is designed for operation over the industrial temperature range of –40°C to 85°C. The TUSB8040 provides simultaneous SuperSpeed and high-speed/full-speed connections on the upstream port and provides SuperSpeed, high-speed,.

TLE7250G : CAN Transceivers The CAN (Control Area Network) serial bus with multi-master capabilities was originally developed for use in automobiles with data rates up to 1Mbps as defined by the ISO 11898 International Standard. Because of its ability to function in harsh automotive environment, CAN has found its way into different applications within modern vehicles,.