Difference between revisions of "IO Expansion Shield"
From Waveshare Wiki
m (Text replace - "{{FAQ box" to "{{FAQ") |
|||
Line 1: | Line 1: | ||
[[Category:Shields| ]][[Category:Arduino| ]] | [[Category:Shields| ]][[Category:Arduino| ]] | ||
[[http://www.utsource.net/wiki/IO_Expansion_Shield 中文]] | [[http://www.utsource.net/wiki/IO_Expansion_Shield 中文]] | ||
+ | [[File:IO-Expansion-Shield_l.jpg|thumb|right|300px |alt=IO-Expansion-Shield|link=http://www.waveshare.com/IO-Expansion-Shield.htm | IO Expansion Shield]] | ||
+ | == Introduction == | ||
+ | Arduino IO Expansion Shield | ||
+ | [http://www.waveshare.com/IO-Expansion-Shield.htm More] | ||
==Resources== | ==Resources== | ||
− | |||
− | |||
− | |||
*[https://www.waveshare.comhttp://www.waveshare.com/w/upload/5/5b/IO_Expansion_Shield_Manual.pdf User Manual] | *[https://www.waveshare.comhttp://www.waveshare.com/w/upload/5/5b/IO_Expansion_Shield_Manual.pdf User Manual] | ||
*[https://www.waveshare.comhttp://www.waveshare.com/w/upload/0/0f/IO-Expansion-Shield-Schematic.pdf Schematic] | *[https://www.waveshare.comhttp://www.waveshare.com/w/upload/0/0f/IO-Expansion-Shield-Schematic.pdf Schematic] |
Revision as of 09:10, 16 November 2015
[中文]
Introduction
Arduino IO Expansion Shield
Resources
Related Modules
FAQ
Answer:
No, this RESET key can be used to reset the XBee and the WIFI-LPT100 only.
{{{5}}}
Answer:
Yes, you can. The IO Expansion Shield provides some conversion interfaces for the Arduino development board to make configuration and communication to the XBee or the WIFI-LPT100. So you can apply the Arduino development board to configure the XBee or the WIFI-LPT100 by setting the corresponding jumpers on the IO Expansion Shield.
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.