IO Expansion Shield

IO Expansion Shield Arduino IO Expansion Shield

{{{name2}}}

{{{name3}}}

{{{name4}}}

{{{name5}}}

Primary Attribute Category: Arduino, Shields, Moduiles, LCD {{{userDefinedInfo}}}: {{{userdefinedvalue}}} Brand: Waveshare

Website International: UTSOURCE website Chinese: 官方中文站点

Onboard Interfaces I2C

Related Products 2.8inch TFT Touch Shield 3.5inch TFT Touch Shield 4inch TFT Touch Shield GSM/GPRS/GPS Shield (B) IO Expansion Shield RS485 CAN Shield Analog Test Shield

Introduction

Arduino IO Expansion Shield

More

Resources

• User Manual
• Schematic
• Code

Related Modules

• WIFI-LPT100

FAQ

Question:Can I use the RESET key on the IO Expansion Shield to reset Arduino development board?

 Answer:

No, this RESET key can be used to reset the XBee and the WIFI-LPT100 only.

{{{3}}}

{{{4}}}

{{{5}}}

Question:Can I configure the XBee or the WIFI-LPT100 installed on the IO Expansion Shield via the serial interface of the Arduino development board?

 Answer:

Yes, you can. The IO Expansion Shield provides some conversion interfaces for the Arduino development board to make configuration and communication to the XBee or the WIFI-LPT100. So you can apply the Arduino development board to configure the XBee or the WIFI-LPT100 by setting the corresponding jumpers on the IO Expansion Shield.

{{{3}}}

{{{4}}}

{{{5}}}

Support

If you require technical support, please go to the Support page and open a ticket.