≥1:
£1.13815
Buy(0)
Inquiry(0)
Dear customers, due to the implementation of the GDPR policy in Europe, UTSOURCE has also made adjustment accordingly to meet the policy requirements. Please read the new privacy policy carefully and this window will no longer pop up after you accept it.
Delivery Address
+ Add Address
The new shipping address
* Please fill in the cell phone number correctly to make sure that you can receive the tracking info in time.
Country CodeSearch results filter:
Home > Elec-component > IC Chips > Linear - Amplifiers - Instrumentation, OP Amps, Buffer Amps
Description: The TCA0372DP2 is a dual SPST CMOS analog switch designed for use with analog and digital signals. Features: * Low power consumption: * 50μA max. for each switch * Low leakage current
Stock:10000
Minimum:2
Favorite
SOP-14
Texas Instruments
06+
The TLE206x series of low-power JFET-input operational amplifiers doubles the bandwidth of the earlier generation TL06x and TL03x BiFET families without significantly increasing power consumption. Texas Instruments Excalibur process also delivers a lower noise floor than the TL06x and TL03x. On-chip zener trimming of offset voltage yields precision grades for dc-coupled applications. The TL206x devices are pin-compatible with other TI BiFETs; they can be used to double the bandwidth of TL06x and TL03x circuits, or to reduce power consumption of TL05x, TL07x, and TL08x circuits by nearly 90%. BiFET operational amplifiers offer the inherently-higher input impedance of the JFET-input transistors, without sacrificing the output drive associated with bipolar amplifiers. This makes them better suited for interfacing with high-impedance sensors or very low-level ac signals. They also feature inherently better ac response than bipolar or CMOS devices having comparable power consumption. The TLE206x family features a high-output-drive circuit capable of driving 100- loads at supplies as low as ±5 V. This makes them uniquely suited for driving transformer loads in modems and other applications requiring good ac characteristics, low power, and high output drive. Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to observe common-mode input voltage limits and output swing when operating from a single supply. DC biasing of the input signal is required and loads should be terminated to a virtual ground node at mid-supply. Texas Instruments TLE2426 integrated virtual ground generator is useful when operating BiFET amplifiers from single supplies. The TLE206x are fully specified at ±15 V and ±5 V. For operation in low-voltage and/or single-supply systems, Texas Instruments LinCMOS families of operational amplifiers (TLC- and TLV-prefixes) are recommended. When moving from BiFET to CMOS amplifiers, particular attention should be paid to slew rate and bandwidth requirements, and output loading. The Texas Instrument TLV2432 and TLV2442 CMOS operational amplifiers are excellent choices to consider.
The TLE2064ACD is a high-speed, low-power operational amplifier manufactured by Texas Instruments. It is a single-channel, low-noise, low-distortion, wide-bandwidth amplifier with a gain bandwidth of
Stock:10000
Minimum:2
Favorite
Stock:2000
Minimum:1
Favorite
DIP-8
On Semiconductor
99+
Dual High-Speed Low-Noise Operational Amplifier 8-PDIP -40 to 85
The MC33078P is an operational amplifier (op amp) manufactured by ON Semiconductor. It is a monolithic integrated circuit designed for use in low-power, high-speed applications. It features a wide ban
Stock:10000
Minimum:3
Favorite
Description: The AD8132AR is a high-speed, low-noise, dual-channel, differential amplifier with a wide gain range from 0.1 to 10 V/V. It is designed to drive a wide variety of loads, including capacit
Stock:2000
Minimum:1
Favorite
SIP-8
ROHM Semiconductor
04+
Dual High Slew Rate, Low Noise Operational Amplifier,
Description: The BA15218N is a high-performance, low-noise, high-output current, low-dropout linear regulator from ROHM. Features: Output current up to 1.5A Low dropout voltage of 0.4V (typ.)
Stock:10000
Minimum:4
Favorite
Description: The OP275GPZ is a low noise, precision operational amplifier from Analog Devices. Features: Low noise: 0.9nV/√Hz Low offset voltage: 2mV Low input bias current: 0.5pA High common-mod
Stock:10000
Minimum:2
Favorite
DIP-8
Ns/st
05+
Dual Operational Amplifier; Package: DIP; No of Pins: 8; Container: Rail
Description: The LM358AN is a dual general-purpose operational amplifier from Texas Instruments. Features: Low power consumption Wide supply voltage range (3V to 32V) High input impedance High ou
Stock:10000
Minimum:5
Favorite
DIP-8
Philips
03+
Single Low-Noise Operational Amplifier; Package: 8 LEAD PDIP; No of Pins: 8; Container: Rail; Qty per Container: 50
Description: The NE5534AN is a low noise, high-speed operational amplifier from Philips Semiconductors. Features: Low noise: 4.5nV/√Hz High slew rate: 13V/μs High input impedance: 2.2MΩ Low dist
Stock:10000
Minimum:2
Favorite
Stock:10000
Minimum:1
Favorite
Description: LM118H is a high performance operational amplifier with a wide range of applications. It has a wide range of operating voltage, low noise, low offset voltage, low input bias current, high
Stock:10000
Minimum:2
Favorite
Description: PA94 is a ZIP-8 package from APEX. Features: - 8-pin package - Low profile - High-speed switching - Low power consumption - High-temperature operation Applications: PA94 is suitable for
Stock:2000
Minimum:1
Favorite
The LM4250CN is a dual operational amplifier (op-amp) from Texas Instruments. It is a high-performance, low-power, low-noise, dual op-amp with a wide range of applications. Description: The LM4250CN
Stock:10000
Minimum:2
Favorite
SOP-14
On Semiconductor
Rail-to-Rail, 1.8-12V Quad Channel Operational Amplifier, Ta = -40 to +105°C - Pb-free; Package: SOIC 14 LEAD; No of Pins: 14; Container: Rail; Qty per Container: 55
Stock:10000
Minimum:2
Favorite
SOP-14
On Semiconductor
3-32V Quad Operational Amplifier with 3mV VIO - Pb-Free; Package: SOIC 14 LEAD; No of Pins: 14; Container: Rail; Qty per Container: 55
Description: The LM324ADG is a low-power quad operational amplifier with true differential inputs. Features: Low Supply Current Drain: 200 μA/amplifier Low Input Bias Current: 25 nA Low Input Offse
Stock:10000
Minimum:4
Favorite
DIP8
Texas Instruments
LME49710 High Performance, High Fidelity Audio Operational Amplifier; Package: MDIP; No of Pins: 8; Qty per Container: 40/Rail
Stock:10000
Minimum:1
Favorite
Description: The BA10358 is a high-performance, low-power, low-noise, dual operational amplifier from ROHM. Features: Low noise: 2.5nV/√Hz Low power consumption: 1.2mA High slew rate: 10V/μs Hig
Stock:10000
Minimum:16
Favorite
SOP-14
National Semiconductor
LM6132/LM6134 Dual and Quad Low Power 10 MHz Rail-to-Rail I/O Operational Amplifiers; Package: SOIC NARROW; No of Pins: 14; Qty per Container: 55/Rail
Stock:10000
Minimum:2
Favorite
Stock:10000
Minimum:1
Favorite
Description: The BA4558N is a dual operational amplifier from ROHM Semiconductor. Features: High gain bandwidth product: 1.2 MHz Low noise voltage: 5.5nV/√Hz High input impedance: 1GΩ Lo
Stock:10000
Minimum:3
Favorite
Stop production experts, we can provide a large number of electronic components that have been stopped production and are difficult to find, to facilitate the maintenance company